Journal of Health and Safety at Work

Influence of different alternative computer keyboards on the wrist and forearm postures

Introduction: In last decades, due to the increase in the number of VDT works prevalence of musculoskeletal disorders has increased among users. One of the main risk factors for those problems might be related to the computer keyboards. Keyboards might lead to these problems, in different ways. Keyboard geometry is one of the main ways. As a result, the various types and shapes of personal computer keyboards have designed in order to provide a neutral or relaxed posture in the wrist and forearm areas. Slanted, sloped and tilted keyboards are the most important alternative keyboard designs for this mean.

Material and Method: In this paper, with a systematic approach, related studies were searched in authentic databases and finally eleven studies met to our inclusion criteria for review.

Result: findings in different studies showed that alternative keyboards clearly can provide an ergonomic neutral posture for the wrist and forearm. As a specific objective in the study, it was found that the best keyboard, to form an ideal posture for the wrist and forearm is ‘NIOSH keyboard‘ because of its ergonomic design.

Conclusion: Considering the positive effect of the alternative keyboards on the wrist and forearm postures, it is concluded that use of the alternative keyboards can decrease risk factors related to the wrist and forearm postures. Results can be applied by personal computer users, computer designers, occupational hygienists and ergonomists.

An investigation on health condition of cattle husbandry units and their

Introduction: Because of some important advantages such as creation job opportunities and providing raw material for some industries, animal husbandry plays an important role in Iran. According to the work force statistics, there are considerable number of employees working in animal husbandries sections. However, there is few information concerning cattle husbandry unit sanitations and workers health and safety condition. The aim of this project was to investigate the health and safety condition of cattle husbandry units and their workers in Babol.

Material and Method: This cross-sectional descriptive study was conducted among all the traditional and industrial cattle husbandry units (n=52) in the rural area of Babol city during winter 2010. The data were collected from all of the active cattle husbandry units, and inactive units were omitted from the sample list. The data were gathered by means of tailor-made data collection sheet through an interview and direct inspection done by the environmental health technicians. The data analyzed using descriptive statistical indexes and Chi- square test, and p<0.05 was considered as significant.

Result: The findings indicated that the mean value of years of work experience was 15.1±12.9 years and 30% of workers were illiterate. Immunization against tetanus was 43%. Only one fourth of the workers had health card and 36% had periodic medical examinations. More than 55% of the participants had not passed health and safety orientation courses. Almost half of the workers experienced work related accidents and 60% of the units had no hygienic toilets. According to Chi-square test result, there were significant statistical correlations between the level of education and years of experience by complying with some health and safety rules.

Conclusion: Our results indicated that, more attention should be given to educational programs about health issues and a serious supervision of health legislations is necessary.

Outline of changes in cortisol and melatonin circadian rhythms in the security guards of Shiraz University of Medical Sciences, Shiraz, Iran

Introduction: According to the literature, a large number of people working in industries and service providing personnel, such as firefighters, physicians, and nurses, are shift workers. The spread of shift working in industrial societies and the incidence of the problems resulting from shift working have caused the researchers to conduct studies on this issue. The present study also aimed to investigate melatonin and cortisol circadian rhythms in the security guards of Shiraz University of Medical Sciences, Shiraz, Iran.

Material and Method: The present study was conducted among 20 security guards of Shiraz University of Medical Sciences. In order to collect the required data, blood samples were taken from the participants in different times of the day (1, 4, 7, 10, 13, 16, 19, and 22) and cortisol and melatonin levels were determined using radioimmunoassay and enzyme immunoassay techniques, respectively. Then, the data were entered into the SPSS statistical software (v. 16.0) and analyzed using One-Way ANOVA.

Result: The results showed that as the intensity of light increased during night time, the level of plasma cortisol increased, as well. Besides, no statistically significant difference was found between the plasma cortisol levels in natural light and 4500-lux light. On the other hand, a significant difference was observed between the level of plasma cortisol in natural light and 9000-lux light as well as 4500- and 9000-lux lights. The study findings also showed that as the intensity of light increased at night, the level of plasma melatonin decreased. In addition, a statistically significant difference was found between the plasma melatonin levels in natural light and 4500-lux light. Nevertheless, no significant difference was observed between the plasma melatonin levels in natural light and 9000-lux light as well as 4500- and 9000-lux lights.

Conclusion: The present study aimed to investigate the subsequences of shift working in the security guards of Shiraz University of Medical Sciences and showed that occupational exposure to bright light could affect some biological markers, such as melatonin and cortisol secretion.

Assessment of reliability of a safety culture questionnaire in the cleanser and washer industries

Introduction: Occupational injuries and accidents as one of the problems have always been considered important in occupational environments. Domino model that Heinrich was formed to pursue the idea of the cause of the accident is the man. Thus one of the effective way to reduce accidents will be control by the unsafe behaviors among workers by promoting safety culture.

Material and Method: In this descriptive - analytical study, the reliability and exploratory factor analysis was used to evaluate the reliability of the questionnaire. In total 303 questionnaires were analyzed using SPSS 17 software.

Result: The alpha crumbed, coefficient was 0/86. Structural factor of the questionnaire was evaluated using factor analysis. KMO and Bartlett’s sphericity test coefficient were 0/909 and 9785/057, respectively. The varimax rotation showed that all test questions are based on factors.

Conclusion: The results indicated favorable validity of this questionnaire for use in detergents and cleaners industries within the country. Considering the load factor safety culture in detergents and cleaners industries, contained 5 factors including “management commitment”, “education and information exchange,” “supportive environment”, “barriers” and “priority to safety”. The obtained the correlations, the highest positive correlation was belong to the “management commitment” (r=0/952), as the strongest correlation with the safety culture.

Determination of noise pollution propagated from agricultural tractors and its driver’s noise exposure level

Introduction: Application of agricultural machineries such as tractor has been yielded a considerable development in different agricultural activities and productions. However, noticeable health problems such as noise pollution impact the users of these off-road vehicles. The purpose of this study was to determine the noise level induced by agricultural tractors and to evaluate the driver’s noise exposure level.

Material and Method: The sound pressure levels of three brands of tractor include John Deere, Ferguson and Romani were measured by sound level meter model Tes-1358. The characteristics of place for measuring tractors noise pollution were determined based on the ISO standard No 7216, 5131. The acquired data was analyzed using spss16 software.

Result: The results showed that the highest and the lowest noise level around the tractors were 83.8 dB (A) and 73.9 dB (A) for the John Deere and Romani, respectively. The effect of different transmission gears on the noise level of tractors was not statistically significant Pvalue>0.05. While, the effect of the tractor engine speeds on the noise level was statistically significant Pvalue<0.01. The exposure time of the most of drivers was frequently about 8 hour or more In this regards, the exposure levels of the tractor’s drivers to noise measured between 85-90 dB (A) were higher than the Iranian occupational exposure limit (85 dB (A)).Moreover, mean noise reduction rate of exsisting room which was used upon the typical tractor’s body was 9.5 dB in one octave band.

Conclusion: Application of standard cockpit and expansion mufflers can effectively reduce noise pollution emission and driver’s occupational exposure. Moreover, regular preventive maintenance and effective hearing conservation program including annual audiometry, hearing protection device, occupational health training for drivers must be implemented.

Investigation of occupational health and safety application using the internal and external factor assessment matrix: SWOT

Introduction: In today comparative markets, the organizations and companies will be success that adopt the standards related to their all works and services. By thechnalization and machinism, we are witnessed of higher rate of industrial accidents as well as economic losses in everyday activities. Therefore, the need for occupational safety and health standards is future required, otherwise, a serious losses will rise for those organizations, accordingly.

Material and Method: IIn this study, the threats, opportunities, weaknesses and strengths were evaluated by one of the tools named SWOT, in one of the assembly industries company in Iran, in order to controlling the operations in this company considering to safety and health standard (OHSAS18001). A comparison of the company’s performance in implementing the safety and health standards was done between years 1387 and 1388 contain in the Company considered, and weighted scoring weaknesses, strengths, threats and opportunities using the matrix of internal factors (strengths and weaknesses) and external factors (treats and opportunities) then, the importance of each factor were determined in the company’s implementation and enforcement of those standards.

Result: Focusing on the strengths and weaknesses, opportunities and threats, some strategies to improve the implementation were presented. Any points were weighted based on the most important weaknesses identified as the lack of monitoring contractors, lack of management commitment for implementation of OHSAS18001, no attempt to identify the risks of change, lack of training needs assessment, main strengths identified in the context of adequate budget health and safety, environmental efforts, identify risk for abnormal conditions, the most important threats for immediate delivery customer orders and the opportunity to support the safety and health plans, were determined.

Conclusion: Sum of the weighted scores in year 87 were obtained for the external factors (opportunities and threats), 2.16 and internal factors (strengths and weaknesses) 1.66. Both of these scores were less than 2.5 (minimum amount of the acceptable rate) so, the company has been poor performance in the implementation of this standard for the year 87 and a weak reaction in the use of opportunities and the minimize threats has. In case of internal factors, it was worse than external one and the situation was more bold of the weaknesses companies to the strengths and of the organization. But, in the year 88, due to changes in the organizational structure of the company, the weighted score for external factors 3.2 and for the internal factors was 3.64, indicating an improvement in the companies conditions.

Study of relationship between personality, attitudes to safety and risky behavior among motorcycle drivers in Tehran city

Introduction: Every year thousands of people in Iran loss their lives in traffic accidents. Any those accidents, motorcycle accidents are fatal. Safety attitude is a predictor of risky behavior. The purpose of this study was to investigate the relationship between personality, attitudes to safety and risky behaviors.

Material and Method: In this study 254 motorcycle drivers were randomly selected in Tehran city, and they were asked to complete personality, the attitude to safety and risky behaviors questionnaire.

Result: A statistically significant correlation was found between different domains of personality (fear, anger, Emotional styles, altruism, anomaly) and attitude to safety (traffic flow in obedience to the law, driving speed, driving excitement), (P = 0/001). Also between personality and attitude to safety the relationship was statistically significant (p = 0/001).

Conclusion: Attitude to safety is a predictor for risky behavior. Personality also the impact indirectly on the attitude to safety have and risky behaviors.

Evaluation of awareness concerning fire prevention and control methods among personnel of operating room in a hospital

Introduction: There are risk of fire accidents in Operating rooms during surgery. Experts estimate annually around 100 fire accidents occur in the operating rooms of United States’s hospitals. 10 to 20 of these accidents lead to severe injuries and about 1 to 2 lead to death. Despite such accidents rarely happen, but they can lead to serious injury or death of patients.

Material and Method: This Cross-sectional questionnaire based survey was conducted among several hospitals belonged to Shiraz University of Medical Sciences. In this study, all personnel of operating rooms were investigated. Questionnaire were used to collect information and the chi-square test was applied to examine the relationship between the Knowledge of operating room personels on fire prevention and control methods, jobs and work experience. For statistical analysis SPSS14 were used.

Result: In this study from 220 participants, about 19.72% had full awareness, 19.62% had partial knowledge, 19.37% had low awareness and 40.97% had no knowledge on fire prevention methods, concerning fire control methods. However, 76% of the participate had full awareness and 24% had no knowledge. Test result Statistically showed that the relationship between the awareness of operating room personnel to fire control methods and work experience were significant (P-value <0.05). But, the relationship between the knowledge of operating room to fire control methods and the type of jobs were not significant. Also no significant relationship were found between the level of awareness in operating room personnel to fire prevention methods, work experience and job title.

Conclusion: The results indicated that the operating room staff awareness of fire prevention and control methods are low. The results also showed that awareness of fires prevention are lower than the awareness of fire control among the studied personel. Regarding to the potential risk of fire in the operating room, it is suggested that in order to increase awareness of vulnerable patients and personnel in operating conditions, measures like educational need assessment, training workshops on fire prevention and control methods should be implemented.