Search published articles


Showing 6 results for Jalili
An Investigation on In-Vessel Composting of Pistachio Residuals with Different Additions
M Jalili, M Mokhtari, Aa Ebrahimi, F Boghri,
Volume 9, Issue 3 (12-2016)
Abstract

Background and Objective: About 1.35×105 tons of pistachio waste are produced in annually Iran that can result in environmental problems if managed improperly. . The purpose of this study was to investigate in-vessel composting of pistachio residuals with addition of cow manure and dewatered sludge as a recycling alternative.

Materials and Methods: Pistachios wastes were combined with weight ratio of 5.5:10 (dewatered sludge: pistachio waste) and weight ratio of 1:10 (Cow manure: pistachio waste) to achieve the carbon to nitrogen ratio of 25:1. The parameters measured were pH, EC, percentage of moisture, total and volatile solids, ash, organic carbon, temperature, and phenol. The 20th edition of SPSS software was used for t-test statistical analysis and comparing the results with standards and Microsoft Excel 2007 was used for drawing the plots.

Results: During the 60-days process of in-vessel composting of pistachio residuals with addition of cow manure, the ratio of carbon to nitrogen reduced from 25:1 to 13:1, dewatered sludge from 25:1 to 14:1; phenol amount in cow maneuver decreased from 4980 to 254 ppm and in dewatered sewage sludge from 6100 to 254 ppm. The maximum temperature in cow manure and dewatered sewage sludge treatments in the composting process reached to 51.9 and 48.9 ˚C respectively.

Conclusion: Results showed that the produced compost with cow manure has a higher fertilizing value compared with the dewatered sewage sludge due to its better organic degradation.


An Investigation on Feasibility of Composting of Yazd WWT Dewatered Sludge with Windrow Method Using Different Treatments
M Mokhtari, A Salehi Vaziri, T Zareyi, M Jalili,
Volume 9, Issue 4 (3-2017)
Abstract

Background and Objective: Dewatered sewage sludge is a by-product of wastewater treatment process which can cause health and environmental problems if not properly managed. The aim of this study was to determine the feasibility of composting of Yazd WWT dewatered sludge with windrow method using different treatments.

Materials and Methods: In this study, the dewatered sewage sludge was mixed with two treatments of agricultural wastes (straw) and green waste (leaves), respectively. The mixture was done based on weight ratio of 20:1 and 10:1 (agricultural waste: dewatered sludge, and green waste: dewatered sludge) to achieve a ratio of C/N:20. The windrows were built with a length of 2 m, width of 75 cm and height of 1.5 m. Composting process was controlled by measuring the temperature, humidity, volatile solids, ash, pH, EC, organic carbon and estimating the C/N ratio. The results were compared with those of the Institute of Standards and Industrial Research of Iran.

Results: After 100 days of composting, C/N ratio was 13.08±6.25 in the treatment with green waste and reached to 15.46±5.35 in the treatment with agricultural waste. The amount of volatile solids decreased to 19.8±14.01% and 20.71±16.06% in the treatments with green waste and agricultural waste, respectively. The amount of EC had an increasing trend in both treatments.

Conclusion: composting with both treatments was led to an improvement in indicators of organic fertilizers in dewatered sewage. However, the windrow containing green waste reached to the mature compost standards sooner than the windrow containing agricultural waste.


Investigation of seasonal changes in the density and diversity pattern of fungal populations in the air around processing facilities of the composting plant
Fariba Abbasi, Mohammad Reza Samaei, Mahrokh Jalili, Hosein Khodadadi, Ali Karimi,
Volume 13, Issue 4 (2-2021)
Abstract
Background and Objective: The aim of this study was to investigate the effect of seasonal variation on the diversity of fungal airborne species in the composting process.
Materials and Methods: Samples were taken based on the 0800 NIOSH method at a height of 1.5 m above the ground during the waste separation, turning of windrow and stabilization of compost. Air samples were collected in two various seasons; summer (108 samples) and winter (108 samples) at the composting plant in Shiraz. The culture media consisted of Sabouraud Dextrose Agar with chloramphenicol for the selective isolation of fungi, which was further incubated at 37 and 45°C. The results were analyzed by a t-test method using MATLAB 2018.
Results: The highest mesophilic fungi density was related to the segregation process of composting. The variation of fungi observed was higher during summer throughout separation and stabilization process (p < 0.05). The predominant species were found to be Aspergillus flavus (4449.8 CFU/m3) (p < 0.05) and Paecilomyces (1850.9 CFU/m3) (p < 0.05), respectively. Furthermore, the highest varieties of fungal species in the turning of windrow mass were observed during winter (p < 0.05) and the predominant species was yeast (420.6 CFU/m3). At all stages of composting, the varieties of thermophilic fungal species were higher during summer with the large number of Aspergillus fumigatus, Mucoral, and Paecilomyces.
Conclusion: The density and diversity of mesophilic fungi during summer was higher than winter. The concentration of Aspergillus, was beyond the guidelines set by the EPA, ACGIH, NIOSH and EU. Thus, the use of self-protection is essential.

Removal N-Methyl Pyrrolidone from petrochemical effluent using photo-Fenton process: a case study of Mahshahr port petrochemical unit
Davood Jalili Naghan, Abdolmajid Fadaei, Alireza Mahmoodi, Rouhollah Khodadadi, Shahnaz Razazi,
Volume 14, Issue 1 (5-2021)
Abstract
Background and Objective: N-methylpyrrolidine is a highly potent solvent with toxic and adverse ecological properties that has historically been widely used in the chemical and petrochemical industries. Due to the health and safety، toxicity and environmental effects of effluents containing NMP، these effluents should be pre-treated before biological treatment methods. The aim of this study was to remove N-methylpyrrolidone by photo- Fenton process.
Materials and Methods: For testing, solutions such as sulfuric acid, iron sulfate 7, oxygenated water, sodium hydroxide and distilled water were added to N-methypyrrolidine compounds in the reactor. Then, the removal process was investigated in two stages: complete mixing and adding solutions.
Results: The results revealed that the Fenton process cannot be used successfully to treat the hypothetical refinery effluent containing NMP. However، the photo-phanton process mineralized and degraded the NMP composition. Increase in 30% H2O2 concentration to the optimal dose of 1 mL led to the highest degradation (94%) and decrease in COD level of solution (42.1%).
Conclusion: It can be concluded that advanced oxidation by photo-phanton reaction can be a promising advanced oxidation technology for decomposition and pre-treatment of NMP-containing wastewaters for further biological treatment.

Identification of the driving forces influencing household waste generation in Tehran (with an emphasis on waste composition) in the next twenty years using the approach of futures studies
Fariba Ebrahimi Fini, Farzam Babaei Semiromi, Mohammad Reza Tabesh, Mahdi Jalili Ghazizade, Amir Hushang Heidari,
Volume 15, Issue 3 (12-2022)
Abstract
Background and Objective: The critical step of policymaking and planning for the local governments to select appropriate waste management methods, is comprehensive information on solid waste generation. Waste generation rate and composition may vary from year to year because many factors influence it. This research identified the most important factors influencing the future of household waste generation and composition in Tehran, and how these factors affect each other.
Materials and Methods: This research is based on future studies methods which are carried out using a combination of quantitative and qualitative models. Due to the nature of this research, structural analysis, Micmac software and Delphi survey were used.
Results: In this regard, after holding many meetings with 22 of the experts as the statistical population of the research, 14 effective factors were identified. The influential factors were then analyzed in the framework of the Cross-impact matrix in the Micmac software. The results showed that what can be understood from the state of the dispersion page of the variables indicated the system instability, with most of the variables dispersed around the diagonal axis of the screen.
Conclusion: Finally, considering the high scores received by direct and indirect influences, 10 key factors were identified. “Economic Growth”, “Digital Transformation and Technological Advances”, “Amendment of Existing laws, Enactment and Implementation of New and Specialized Laws”, and “Increased Awareness about waste and Attraction of Citizen Participation through Education and Provision of Information” were identified among these 10 factors as the driving forces influencing generation and composition, of household waste in Tehran in the Next Twenty Years.
 

Evaluation of microbial characteristics of traditional butter made from cow and sheep milk in Ilam city, Iran
Nahid Jalilian, Abdullah Sheykhi, Leila Mirzaei, Zeinab Gholami, Moayed Adiban,
Volume 16, Issue 2 (9-2023)
Abstract
Background and Objective: Butter is a known dairy product in the world and has an important role in human nutrition. Ignoring sanitary tips in this product leads to low quality of the product and outbreak. Therefore, this study aims to investigate bacterial pollution of local butter produced from cow and sheep milk in Ilam city.
Materials and Methods: In this analytical study, 150 samples of traditional cow and sheep butter were collected and studied for microbial contamination for 1 month from different production centers. SPSS version 23 software was used to analyze the collected data.
Results: From 75 samples of cow butter, 25.3% of the samples are polluted to S. aureus, 44% to S. epidermidis, 38.7% to Salmonella, 12% to Total coliform 10.7% to E. coli, and 12% do not have any pollution. From 75 samples of sheep local butter, 12% of the samples are polluted to S. aureus, 72% to S. epidermidis, 48% to Salmonella, 24% to Total coliform, and 17.3% to E. coli. A significant difference (P< 0.05) between pollution to S. aureus and S. epidermis in cow and sheep samples exists.
Conclusion: The results of this study showed that contamination of consumed local butter in Ilam city is considerably high; Therefore, it is important to pay attention to food hygiene in different stages from production to consumption.
 

Page 1 from 1     

© 2024 , Tehran University of Medical Sciences, CC BY-NC 4.0

Designed & Developed by: Yektaweb