Iranian Journal of

Backgrounds and Objectives:Much attention has been recently paid on using waste materials as adsorbents for removal of contaminants from water and wastewater. A new low cost waste was examined for its capacity to adsorb RR198, an azo reactive model dye, from an aqueous solution.
Materials andMethods: The waste was dried, powdered and characterized before being used as an adsorbent. The effects of pH (3-10), adsorbent dose (0.2-3 g), dye concentration and contact time on the adsorption efficiency were investigated. Equilibrium study data were modeled using Langmuir and Freundlich models.
Results: The characterization analysis indicated that itwas composedmainly of ferric hydroxide. The powder had a BET and average pore size of 107 m2/g and 4.5 nm, respectively. The results showed that dye removal was highest at a solution pH of 7 to 8 and a powder dose of 2 g/L. The RR198 removal percentage decreased from 100& to 43& at 140 min contact time when the concentration of dye was increased from 25 mg/L to 100 mg/L, at optimum pH and dosage. The Langmuir equation provided the best fit for the experimental data. The maximum adsorption capacity was calculated to be 34.4 mg/g.
Conclusion: According to the obtained results, the water coagulation waste sludge appears to be a suitable low cost and effcient adsorbent for removing reactive azo dyes from waste streams.

Backgrounds and Objectives: Carcinogenic and mutagenic potential of some azo dyes as a category of common dyes in different types of industries has been reported. The degradation of one commercially available dyestuff [C.I. Reactive Red 198 (RR 198)] by means of ultraviolet radiation (UV), ultrasonic irradiation (US), UV/H2O2 and US/H2O2 processes was investigated.
Materials and Methods: Photolysis process was accomplished in a laboratory-scale batch photoreactor equipped with an 55W immersed-type low-pressure mercury vapour lamp (UVC) and sonication in a sonoreactor with low frequency (42 kHz) plate type transducer at 170W of acoustic power with emphasis on the effect of various parameters on decolouration and degradation efficiency.
Results: Initial results showed that, color removal efficiencies by US and US/H2O2 processes were negligible. Almost complete disappearance of RR 198 (20 mg/L) in UV/H2O2 process was possible to achieve after 10 min of irradiation. It is found that lower pH and lower concentration of dye favor the dye degradation. Hence any increase in initial dye concentration results in decreased decolouration rates. Also, the experimental results indicated that the kinetics of sono-oxidation and photo-oxidation processes fit well by pseudo-first order kinetics and first order reaction kinetics, respectively.
Conclusion: It is concluded that UV/H2O2 reaction was more effective than other reactions in bleaching and the reaction rate was sensitive to the operational parameters and increased with increasing H2O2 concentration up to 15 mM.

Background and Objective: Reactive Red 198 is a mono azo dye widely used in the textile industry of Iran. The toxicity of reactive dyes is higher than other dyes and causes disorders such as irritation, cancer and mutation in humans. The overall objective of this study was to determine the efficiency of a Constructed Wetland pilot system with conventional and baffled horizontal subsurface flow to remove Reactive Red 198.
Materials and Methods: In order to remove Reactive Red 198, two cells were constructed in parallel with 2 × 0.6 × 0.5 m. In the conventional and baffled cell, native straw of Phragmites australis was used. In the research process, COD concentration and reactive dye concentration were investigated. The effect of retention time and type of plant on the efficiency were also investigated.
Results: The results showed that the maximum removal efficiency of the Reactive Red dye 198 was obtained at 100 mg/L inlet pollutant concentration and 3.5 days retention time, which was related to the baffled cells. Also, the presence of the baffles in the constructed wetland system increased the removal efficiency. The presence of straw in both cells was directly affected the removal efficiency. The effect of the retention time in the conventional cell was more effective in removal efficiency than the baffled cell. The pollutant inlet concentration was also inversely correlated with the removal efficiency.
Conclusion: According to the results, it can be concluded that the baffled and conventional horizontal subsurface constructed wetland can be used for low concentrations and at low retention time as a well-functioning system in the removal of Reactive Red 198.