Showing 3 results for Removal Efficiency
N Daneshi, H Banejad, R Pirtaj Hamedani, H Farajee,
Volume 3, Issue 3 (10-2010)
Abstract
Backgrounds and Objectives: Due to copper and zinc elements toxicity, a greatly attention to removal of those in order to reduce environmental pollution exist. This experiment was conducted to investigate the study of the effect of gravity single layer rapid sand filter on heavy metals (zinc and copper) removal efficiency in aquatic condition in different phosphate concentration.
Materials and Methods: this study applied a gravity single layer rapid sand filter with silica sand media. Experiments conducted for all of the states of Cooper and Zinc concentration in 25, 75, 125 and 175 ppm at different phosphate concentration present by varied discharge. Each state of Solutions pumped on top of the bed and discharge adjusted. Samples taken fromeffluent then acidified immediately with nitric acid. Metals concentration perused by atomic emission spectrometer with ICP source. Collected data analyzed by SPSS software.
Results: Founds from this study shown that maximum removal efficiency for copper and zinc was 98.89%and 78.60%respectively effect of discharge,metal concentration and phosphate concentration factors in removal efficiency of zinc and cooper, discharge and phosphate concentration bilateral effect on cooper removal efficiency, phosphate concentration andmetal concentration bilateral on zinc removal efficiency, are significant in 1%. In addition, phosphate concentration and discharge bilateral effect, metal concentration and discharge bilateral effect are significant on zinc removal efficiency in 5%. Finally, bilateral effects of discharge and metal concentration also metal concentration and phosphate concentration have not significant effect on cooper removal efficiency.
Conclusion: Gravity single layer of rapid sandy filter with silica sand media in order to cooper removal in low concentration can be used successfully. This method in high concentration of cooper and also different concentration of zinc had not successful result but in this condition, may be use
of a series of filter with more depth
Hafez Golstanifar, Simin Nasseri, Amir Hossin Mahvi, Mohamad Hadi Dehghani, Anvar Asadi ,
Volume 5, Issue 4 (2-2013)
Abstract
Background and Objectives: The contamination of nitrate (NO3−) in groundwater resources causes two adverse health effects: induction of “blue-baby syndrome” (methemoglobinemia), especially in infants, and the potential formation of carcinogenic nitrosamines. The aim of this research is to investigate nitrate removal from groundwater using alumina nanoparticles and to determine the adsorption isotherms.
Materials and Methods: This analytical-descriptive study was carried out at lab-scale, under batch conditions, and at room-temperature. The structure of alumina nanoparticles was determined using XRD, SEM, and TEM techniques. The concentration of nitrate in the solutions was determined by spectrophotometer at wavelengths of 220 and 275 nm. In addition, we investigated the impact of the important operational parameters including initial dose of Al2O3 (0.06-0.25 g/l), initial concentration of the solution (50- 300 mg/l), contact time (5-60 min), and pH (3-9). Moreover, we used Freundlich and Langmuir isotherm models to calculate equilibrium constant.
Results: It was found that nitrate removal efficiency increased as we increased contact time, initial concentration and pH in batch system. A maximum of 60% nitrate removal was achieved under following conditions: 60 min contact time, pH 5, and initial nitrate concentration of 300 mg/l as N. The obtained results showed that the adsorption of nitrate by Nano-Gamma-Alumina follows Langmuir isotherm equation with a correlation coefficient equal to 0.982.
Conclusion: Overall, our findings showed that the alumina nanoparticles can be used as an effective adsorbent to remove NO3 from aqueous solutions.
Marzieh Razavi, Mosen Saeedi, Ebrahim Jabaari,
Volume 6, Issue 3 (12-2013)
Abstract
Background & Objectives: In this study, treatability of wastewater from a laundry unit was investigated by applying electrocoagulation method in which two pairs of aluminum and iron electrodes were utilized. Electrocoagulation is a noble treatment method suitable for different kinds of wastewater which has been given a considerable attentions by researchers recently. Applying direct current to two or several suitable metallic electrode in a batch reactor containing effluent would result in flocks of metal hydroxide.
Materials & Methods: We studied the effect of different operational parameters such as pH, electrodes distance, intensity of electrical current, and type of electrodes on the treatment efficiencies.
Results: Aluminum electrodes showed better effects on the treatment efficiencies in nitrate and COD removal. Maximum phosphate removal (99.93%)took place at pH=7 using Al electrodes. Whereas, in the case of iron electrode, maximum nitrate and COD removal efficiencies were about 97.60 and 80% at pH=9 and pH=6 respectively. Operational cost analysis showed that the corresponding costs of Al application as an electrode is different from that of iron electrode application.
Conclusion: Although application of both iron and aluminum electrodes lead to obtaining considerable removal phosphate, nitrate and COD, iron electrodes could result in reasonable removals to meet Environmental Standards with lower operational costs.
