S. Nokar , A. Monzavi , F. Hashemi ,
Volume 15, Issue 2 (5-2002)
Abstract
Retention, resistance and marginal integrity mostly depend on tooth preparation. An appropriate convergence angle fulfil this purpose, to high extent. In this study, a new method was used to measure the convergence angle of the teeth prepared for single crowns in Genera! practitioners" offices in Tehran. In order to do this. 325 dyes, prepared by General dentists in Tehran, were collected from 10 laboratories. All dyes wore trimmed at the area below the finishing line and then were scanned (Genius Color page- FIR 6) buccoiingualiy and mesiodistaily. Convergence angle of dyes were also measured with Adobe Photoshop (5.0) software. Data were analyzed by variance analysis test and 1- student bv the help of SPSS software. Results showed that the average convergence angle ranged from 16.18+8.34 to 35.1 8~10.38 which belonged to maxillary canine and mandibular molars, respectively, and the measured convergence angle is more than the ideal value of 10-16 degrees. Dyes of the madibular molars were ma"illar" convergent. These conclusions are helpful for professors, dentistry students and dentists, and arc an indicative of the practice quality of General practitioners in Tehran. Due to the fact that a convergence angle, more than the allowed limitation, endangers retention, resistance and marginal integrity of the restoration, paying attention to the principles of tooth preparation and proper application of instruments and dental cements, can progress fwed restorations quality.
Hamid Jalali, Farzaneh Farid, Abdolsalam Abobakry, Maryam Mohajerfar,
Volume 25, Issue 2 (4-2012)
Abstract
Background and Aims: The purpose of this study was to design a new device assisting dental students to measure the tapering of the prepared teeth for fixed crown prosthesis in which the desired tapering for better clinical prognosis could be obtained.
Materials and Methods: The designed device in this study had two arms that were placed on two opposite walls of the prepared teeth. To evaluate the validity and reliability of this device, 3 dies with different degrees (13, 29 and 45°) were used and 20 teeth were prepared by dental students with undefined tapering degrees. The measurements of tapering were performed by six last year-dental students in two different time periods. Comparison of errors in measurements on standard dies between observers and between time intervals were analyzed by (Wilcoxon) Paired t-test with a significance level of α=0.05.
Results: For the three dies used in this study, we compared the differences for each measurement taken by observers with the standard taper of the dies. Maximum difference of measurements with true standard die tapering was 1 degree. A number of 6 measurements were under the true standard tapers and 2 measurements were above it. Interclass Correlation Coefficients (ICC) of the first and second measurements on prepared teeth were 97.4 and 97.5, respectively. There were no significant differences between different observers or two measurements of the same observer in different time intervals (P>0.05).
Conclusion: The results indicated that this device can be valid and reliable for measuring the angle of convergence of the prepared teeth and can be used as an educational device in dental schools as a replacement for previous tapering measurement methods.
