F. Nejatidanesh , O. Savabi , B. Sarrafpour , D. Mirabi ,
Volume 20, Issue 1 (5-2007)
Abstract
Background and Aim: Proper designing of partial denture frameworks is the duty of dentists, but this task is often abdicated to technicians because of lack of time and experience. Computer assisted learning and designing can be used for both training dental students and helping dentists design proper frameworks. As the first step to prepare software for framework designing, this study evaluated the agreement on different framework designing principles, among prosthodontists of dental schools in Iran.
Materials and Methods: A questionnaire consisting of 121 design rules was sent to 41 prosthodontists at seven dental schools in Iran .The percentage rate of agreement on results was used for data analysis.
Results: The percentage of rules accepted by more than 60% of the prosthodontists was 76.2%. It consisted 80% saddle rules, 76.2% rest rules, 78.4% clasp rules, 63.6% maxillary major connector's rules and 80.9% mandibular major connector rules.
Conclusion: The percentage of accepted rules by Iranian prosthodontists was 76.2%. Maxillary major connectors had the least acceptance.
F. Nejatidanesh , O. Savabi , B. Sarrafpour , D. Mirabi ,
Volume 20, Issue 2 (5-2007)
Abstract
Background and Aim: Designing removable partial dentures is one of the most important phases of prosthetic treatments. Computer can be used to facilitate and increase accuracy of removable partial denture design. The aim of this study was to develop a software for removable partial denture design.
Materials and Methods: A questionnaire (discussed in part I) and major textbooks, were used to determine the design rules. The software (RPD Graph) was developed using Visual C++ and Maryam program. The RPD Graph can determine the classification of partial edentulous arch. With defining the missing teeth and providing data about prognosis and conditions of abutment teeth, the removable partial design will be developed by RPD Graph. This software is a knowledge-based system which has specific characteristics. It can be used as an educational tool for teaching RPD design and as a clinical tool for supporting clinician's decision. In addition it can be developed to more complete softwares.
A. Rohanian, Gh. Ommati Shabestari,
Volume 23, Issue 1 (6-2010)
Abstract
Microstomia is defined as an abnormally small oral orifice. Microstomia can occur as a result of trauma from electrical and thermal lesions, chemical burns and trauma from surgeries. Prosthetic rehabilitation of microstomia patients presents difficulties at all stages, from the preliminary impressions to fabrication of prosthesis. For impression procedures different treatment methods have been suggested. Swing hinge and collapsible dentures are used to provide prosthodontic treatment to patients with microstomia. Not only is such a prosthesis difficult to fabricate, but may be expensive. The literature contains reports on the fabrication of sectional denture with the denture pieces connected by different designs. This article describes a simple method of fabricating a 2-pieces denture using removeable partial denture metal framework to connect the sections, for a patient with limited oral opening. Combination of metal framework and sectional complete denture for a patient with limited oral opening is an acceptable, effective and available method.
