Search published articles


Showing 6 results for Primary Teeth

A. Kowsari , B. Seraj , N.   Pasdar ,
Volume 15, Issue 1 (3-2002)
Abstract

Due to the differences in the composite and morphology of dentin in primary and permanent teeth, it is necessary to make improvements in bonding techniques to promote the strength of composite resins bonded to the dentinal surface, in primary teeth. The use of lower radiation, to make structural and chemical changes in dentinal surfaces has been investigated. This research was conducted to evaluate the shear strength of the composite bonded to primary teeth dentin after Nd: YAG laser radiation and acid etching for conditioning. Peripheral dentin of the buccal and lingua! surfaces of 60 extracted posterior primary teeth were exposed and polished with 600 grit with Sic paper. The teeth were divided randomly in 3 groups of 20 teeth. In group 1 etching gel, primer and adhesive of scotch bond multipurpose system (SMP), in group 2 laser at 1.6 w and 80 mj/pulse, and in group 3 laser at 2 s and 700 mj/pulse were used. Moreover, in groups 2 and 3, after laser radiation, acid etching, primer and adhesive of SMP system were applied. After necessary laboratory tests, the mean shear bond strength in MPa were 20.99±5.3 (group 1), 23.82±6.31 (group 2) and 26.58±5.59 (group 3). ANOVA, scheffe, tukey statistical tests showed that the bond strengths of group 3 were statistically higher than group 1. The frequency of dentin cohesive failures were significantly higher in groups 2 and 3, compared to group 1 that indicates a higher bond strength in these groups. Scanning electron mirographs of laser radiated surfaces, show a porous and rough surface morphology that enhances the mechanical bond of the composite.
A. Makarem , M. Ghavam Nassiri , M. Esmaili ,
Volume 19, Issue 4 (1-2007)
Abstract

Background and Aim: Nanoleakage can cause discoloration around restoration margins, secondary caries, postoperative sensitivity and finally loss of restoration, thus adequate hybrid layer is of primary importance in prevention of nanoleakage in adhesive restorations. Because of structural differences between primary and permanent dentin, evaluation of nanoleakge in primary teeth is very important. The aim of this study was to evaluate the nanoleakage in composite restorations following application of self -etch and total-etch adhesives in primary and permanent teeth.

Materials and Methods: In this experimental study, Cl V cavities were prepared in buccal surfaces of 20 extracted primary molars and 20 extracted premolars. Each group was divided into 2 subgroups: In group (A), Gluma One Bond and in group (B), iBond adhesive materials were applied. After silver nitrate staining, specimens were mesiodistally sectioned and polished and then SEM examination was carried out to measure the nanoleakage .Data were analyzed statistically using, ANOVA and Duncan tests with p<0.05 as the limit of significance.

Results: Factors tested had no significant effect on each other. Primary teeth showed more nanoleakage than permanent teeth (P<0.05). Mean nanoleakage was significantly higher in cervical than occlusal margins (P<0.05) and also in iBond than in Gluma One Bond in primary teeth (P<0.05). In permanent teeth, the lowest nanoleakage was observed in Gluma One Bond.

Conclusion: The result of this study indicates that the use of total etch dentin adhesives (Gluma One Bond) in bonded restorations results in less nanoleakage in primary and permanent teeth.


R. Haghgoo, F. Abbasi,
Volume 23, Issue 1 (6-2010)
Abstract

Background and Aims: Formocresol is one of the most common pulpotomy medicaments for primary teeth. Because of its systemic and local side effects, it may be essential to use another material instead of formocresol. The aim of this study was to evaluate the histopothalogy of pulp after pulpotomy teeth with sodium hypochlorite and formocresol.

Materials and Methods: In this randomized clinical trial, 22 canine teeth that must be extracted because of orthodontic treatment were selected. The teeth were randomly divided into 2 groups (n=11) and pulpotomized with formocresol or sodium hypochlorite. These teeth were extracted after 2 months and pulpal response was evaluated according to the degree of inflammation and extent of pulpal involvement. Dentinal bridge formation was also evaluated. The data were analyzed by Mann-Whitney test.

Results: In formocresol group, mild inflammation was seen in 4 and moderate inflammation in 3 and severe inflammation in 4 cases. In sodium hypochlorite group mild inflammation was seen in 6 cases and moderate inflammation in 4 cases and severe inflammation in 1 case. Mann-Whitney test revealed that this difference was not statistically significant (P>0.05). In formocresol group, necrosis was seen in 5 cases, but abscess and internal resorption were not seen in any cases. In sodium hypochlorite group, internal resorption was seen in 3 cases but necrosis and abscess were not seen in any cases.  Mann-Whitney test showed that the difference between two groups was significant in terms of necrosis (P=0.02). In sodium hypochlorite group, dentinal bridge was formed in 3 cases however, no dentinal bridge formation was seen in formocresol group. Mann-Whitney test showed that this difference was not significant statistically (P>0.05).

Conclusion: Based on the results of this study, sodium hypochlorite can be used as a pulpotomy agent in primary teeth.


Z. Bahrololoomi, Aa. Soleymani, P. Namiranian,
Volume 24, Issue 2 (4-2011)
Abstract

Background and Aims: Use of glass ionomer cements in pediatric dentistry is increasing and limited information exists with regard to the effect of salivary contamination on the shear bond strength of glass-ionomer to dentin in primary teeth. The aim of this study was to evaluate the effect of salivary contamination on the shear bond strength of two types of glass ionomer cements to dentin in primary teeth.
Materials and Methods: A total of 36 human extracted primary molars were used in this study. The specimens were divided into two groups for each material and then further subdivided into three groups: group 1: uncontaminated, group 2: contaminated with saliva, group 3: contaminated, washed and air dried. The specimens in groups I, II, III were bonded to glass-ionomer and in groups IV, V, VI to resin modified glass-ionomer. Shear bond strength was measured using an Instron machine at 1 mm/min cross head speed. Data were analyzed with ANOVA and Tukey test.
Results: There were significant differences in the mean shear bond strength among groups IV, V (P=0.05). There were no significant difference among groups I & II (P=0.16), I & III (P= 0.93) and IV & VI (P=0.98).
Conclusion: Results showed that salivary contamination can decrease the mean shear bond strength of light- cured glass-ionomer to dentin in primary teeth.


Ahmad Jafari, Masoud Kiani, Mahin Nikkhah, Ronak Bakhtiari, Yahya Baradaran Nakhjavani, Ali Reza Heidari,
Volume 27, Issue 3 (9-2014)
Abstract

  Background and Aims: Considering the complications of root canal system, debridement would not be effective only by mechanical instrumentation. Therefore, root canal irrigants with the antimicrobial effect that can eliminate more microorganisms during treatment, becomes important. The aim of this study was to compare the antimicrobial effects of 2% thyme essence, 2.5% sodium hypochlorite (NaClO), and normal saline as root canal irrigants for primary molar teeth.

  Materials and Methods: This study was performed on 34 primary molars. Subjects were randomly divided into three groups (N=10). The root canals of the teeth were prepared up to the file #35 and all of the specimens were sterilized, and were then contaminated with entrococccus faecalis suspension (Enterococcus Faecalis ATTC 29212). After 48 hours of incubation, the specimens of each group were irrigated with corresponding irrigants. Then, the microbial specimens were collected with sterile paper points. After incubation, the numbers of Colony Forming Units (CFU) were counted using colony counter. Data were analyzed using Smirnov-Kolmogorov, Kruskal-Wallis and Mann-Whitney tests.

  Results: Sodium hypochlorite showed the highest antimicrobial effect and showed significant differences compared with normal saline (P<0.001). However, the differences were not significant with thyme essence 2% (P=0.3).

  Conclusion: Thyme essence could be considered as a natural irrigator with a comparable antiseptic effect to sodium hypochlorite.


Mehrdad Kahvand, Mostafa Vahedian, Mansoureh Hadadzadeh, Ali Saleh, Aida Mehdipour,
Volume 36, Issue 0 (5-2023)
Abstract

Background and Aims: One of the concerns of dentists is selecting a suitable brand of stainless steel crowns with maximum dimensional adaptation with primary teeth. The aim of this study was to compare the primary molar crown dimensions with that of two brands of stainless steel crowns (SSCs) in a sample of Iranian children.
Materials and Methods:  In this study, 130 eligible children between 3 and 12 years (66 boys, 64 girls) were selected. After recording the demographic information, the mesiodistal, buccolingual and occluso-gingival dimensions of first (D) and second (E) primary molars were measured on dental casts and compared with the dimensions of KTR (MeiMeiMinBenjing, Benjing, China) and Shinghung (Shinhungcompany, Seoul, South Korea) SSCs. Data were assessed using chi-square test and Pearson correlation coefficient. P<0.05 was considered statistically significant.
Results: In this study, the most dimension matching of the teeth with that of SSCs were observed mesiodistally in upper D and lower D, buccolingualy in the upper D and lower D, and occluso-gingivaly in upper D and lower E. The most cases of mismatch in the mesiodistal dimensions of the teeth with that of SSCs were observed in the lower E and upper D. Also, the most cases of mismatch in the buccolingual dimension were found for upper E and lower E.
Conclusion: Both SSCs brands in this study showed significant dimensional adaptation with the primary teeth in Iranian children. The most dimensional adaptation was between KTR SSCs and maxillary primary molars, and between Shinhung SSCs and mandibular primary molars.


Page 1 from 1     

© 2024 , Tehran University of Medical Sciences, CC BY-NC 4.0

Designed & Developed by: Yektaweb