Journal of Health and Safety at Work

---

Introduction: The most common standards being used for predicting the health risks of whole body vibrations are ISO 2631- and BS 6844, presenting frequency weighting anfd different coefficients for different sensivities in variuse axes. In yhis study, vibration was measured about 900 minutes on 9 trains in one of the active lines of tehran metro with the aim of comparing the mentioned standards in evaluating whole body vibation.

.

Material and Method: In this research, in addition to evaluation of different kinds of vibration indicators, the differences of ISO 26331-1 and BS 6841 Standards have also been investigated. The amounts of r.m.s., vibration dose and daily vibration dose were measured in x, y and z axes for drivers seat and x axis for drivers back rest separately according to the instruction of the two standards.

.

Result: The mean calculated values of r.m.s and vibration dose on a basis of 135 6841 standard were lower than those values calculated according to ISO 2631 standard. Moreover, the results showed that 3 cases, based on the ISO standard, had risk level of higher than 17 m/s1.75 and 3 cases, had risk level of higher than 15 m/s1.75 value, provided by BS 6841.

.

Conclusion: Calculation according to the ISO 2631-1 standard show higher values. Indeed, ISO 2631-1 can provide a more secure criterion company to BS 6841, although the 15 m/s1.75 in BS is lower than the highest level of health guidance caution zone in ISO. Additionally, the association between r.m.s and vibration dose values in ISO 2631 is relatively lower than this association in BS 6841.

---

Introduction: Patient safety is an important issue in regard to hospital servicesand any problem can cause adverse consequences. The purpose of this study was to assess the patients’safety culture at educational hospitals in Tehran.

.

Material and Method: The present descriptive-cross sectional study was carried out among 312 health care workers in Baharloo, Amir Aalam, Shariati and Sina hospitals in Tehran, which were selected by cluster sampling. The participants were chosen randomly in each cluster. Safety Culture Survey questionnaire including 12 dimensions was used to assess patient safety culture. Cronbach’s alpha and test-retest coefficient were estimated 81 and 79 percent, respectively.

.

Result: Nurses comprised 61 percent of participants in the study. 42% of staff had less than 5 years work experience. Of the 12 dimensions of patient safety culture, the frequency of reporting and exchange of information had the minimum average of 56 and 55, respectively. Moreover, the dimensions of organizational learning and expectations-management measuresobtained the highestmean score (69)among 12 dimensions of patient safety culture. Total mean patient safety culture in understudy hospitals was 63.

.

Conclusion: It should be noted that paying more attention to the patient safety culture can lead to improve hospitals condition, as a whole, and to have a patient-friendly environment. Special attention should be paid to dimensions with the lowest mean score in order to strengthen them.

---

Introduction: In Laboratory accusations a wide range of hand-held tools are used due to nature of their work. Long-term and repeated use of these tools has led the laboratory workers to suffer from upper limb disorders. The present study was designed and implemented with the aim of investigating the usability of different models of pipettes used in the laboratories of the Tehran University of Medical Sciences, employing subjective assessment methods for selecting the best pipette models.

.

Material and Method: This cross-sectional and analytical-descriptive study was performed among 35 laboratories employees of Tehran University of Medical Sciences. First, four models of the widely used pipettes were selected and their usability-related characteristics were investigated by a visual analog scale (VAS). Judgments concerned the usability of the pipettes done based on the criteria provided by the International Organization for Standardization 9241-11(1998) and 20282-2(2006). Data analysis was performed, using SPSS software version 22.

.

Result: The overall evaluation of the users in relation to the characteristics of the pipettes indicated that the highest VAS score was belonged to pipette A, C, and D, respectively. Furthermore, pipette B was selected as the most undesirable one by users. Results related to the usability criteria of pipette showed that of the four models of study pipettes, pipette A has been ranked first in two criteria (satisfaction and effectiveness). Regarding the efficiency, the first rank was for C pipette and the second rank was for pipette A. Pipette B obtained the lowest scores for all given criteria.

.

Conclusion: Shorter and lighter pipettes, which were designed according to ergonomic principles, had greater usability from the perspective of users and it could cause a better subjective assessment comparing to the other models.

---

Introduction: Nowadays, demand for protection against radar radiation using electromagnetic shielding is on the rise.  Double-layer or multilayer shielding were devised in order to improve the single layer electromagnetic shielding properties. In this study, we tried to prepare a new double-layers electromagnetic shield and investigate the effect of structural factors such as thickness, similarity in layers and mixing time on the shielding effectiveness for double-layers shields.

Material and Method: This study used the Resin Epoxy EI-403 and Nickel Oxide nanoparticles to prepare single layer shields by casting method (with two different mixing time: 10 and 66 min) in 2, 4 and 6 mm thicknesses and 7 wt% Nickel oxide nanoparticles. Then, in order to prepare double-layers shields, single-layer shields were placed on each other without air space. Scattering parameters were measured by a Vector Network Analyzer (V.N.A) and shielding effectiveness were calculated in X-band radar frequency range.

Result: The highest and the lowest averages of shielding effectiveness in single layer shields were 84.14% and 46.05%, respectively. These values were 66.34% and 41.99 %, in double layers electromagnetic shields. The averages of shielding effectiveness values in the double-layers shields (with 10 min in mixing time) in 6, 8 and 10 mm in thickness were 41.99%, 45.45% and 43.25%, respectively. These values in 66 min in mixing time, increased to 54.30%, 62.07% and 66.34%, respectively.

Conclusion: In this study, the shielding effectiveness in double-layers were less than single layer electromagnetic shields. Although the increase in mixing time improved the shielding effectiveness of both single and double layer shields, it could not increase the shielding effectiveness in double layer shields in comparison with single layer. Also, the increase in mixing time in double-layer shields showed that shielding effectiveness decreased with increasing thickness in these shields. Also, it was seen that using a similar single-layer shield in the structural of a double-layer shield led to an increase in skin depth and multi reflections .It finally reduced the shielding efficiency in double layer. It is suggested that in the future, other studies be conduct to improve the shielding effectiveness in these electromagnetic shields.

---

Introduction: Work-related musculoskeletal disorders (WMSDs) are one of the most important causes of absenteeism, increased costs and human injuries, which are very common in computer users. The purpose of this study was to investigate the effect of 8 weeks of corrective exercise on reducing the prevalence of musculoskeletal disorders (MSDs) in computer users working in a gas company.
Material and Methods: This cross-analytical study was conducted on 101 computer users working in a Gas Company in Qazvin city in 2019. Fourteen people participated in 8 weeks correction training intervention program (16 sessions in 1 hour and 2 times a week). Nordic questionnaire and body map were used in order to investigate the prevalence and severity of MSDs. The data were analyzed using Kolmogorov-Smirnov, Cramer V, McNamar, Paired sample t-test and Wilcoxon tests in SPSS version 23 software.
Results: The most common disorders were shoulder (64.3%), waist (42.9%) and neck (35.7%) regions among computer users during the last week before intervention. The prevalence of MSDsby strength and flexion exercises in neck and shoulder regions with 95% and 99% confidence showed a significant decrease before and after intervention. The incidence of discomfort in the waist region decreased by 35.8% after intervention and in other regions decreased by at least 7.1%.
Conclusion: The results of this study showed that implementation of corrective training intervention program by exercise specialists can increase muscle stretch and consequently decrease the prevalence of MSDs7.1%- 64.3%.

---

Introduction: The purpose of the current study was to predict the percentage of the sway index from the static balance point based on the anthropometric dimensions of construction workers.
Material and Methods: This descriptive-analytical study was conducted on 114 construction workers. First, the construction workers were asked to complete the demographic questionnaire and the inclusion criteria were determined. Then, the anthropometric dimensions were measured. Afterward, the static balance of participants was assessed with their open eyes and standing position using a Stabilometer device. The obtained data were analyzed using Pearson correlation and multiple linear regression.
Results: 29.8% of construction workers were in weak and very weak classes in terms of static balance. The Pearson and spearman’s correlation coefficient showed a significant relationship between age, weight, and sway index of individuals. In addition, multiple linear regression showed that age, weight, and foot surface of construction workers can predict the percentage of the sway index from the static balance point among construction workers.
Conclusion: The results of the current study indicated that demographic information such as age, anthropometric parameters of weight, and foot surface are effective factors on static balance in a healthy construction workers’ community with a normal body mass index.

---

Introduction: Using backpacks has arisen complaints regarding musculoskeletal pains among students. The aim of this study is to investigate the relationship between demographic information and bag weight with Neck Disability Index (NDI), angles and head and neck postures among students.
Material and Methods: This descriptive-analytical and cross-sectional study was conducted among 80 students who were selected randomly. Demographic information and NDI questionnaires were used for data collection. The head and neck tilt angles and the amount of change in the forward head posture were determined using the photogrammetry method and Kinovea software.
Results: A negative and significant correlation was observed between head tilt angle with age (r = - 0.27) and neck tilt angle with body mass index (r = - 0.37). Also, a positive and significant correlation was observed between the amount of change in the forward head posture and body weight (r = 0.24). The head tilt angle was significantly different in male and female students at different educational levels. NDI (r = 0.23) and neck tilt angle (r = 0.26) also increased significantly with increasing bag weight.
Conclusion: Reviewing the standard weight of bag and changing the lifestyle can play an important role in improving the head and neck angles and postures.