Showing 3 results for Methan
Rezvan Ghashghaei, Gholam Reza Sabzghabaei, Soolmaz Dashti, Samira Jafari Azar, Farhad Salehipour,
Volume 9, Issue 2 (6-2019)
Abstract
Introduction: The accidents involving the transport of hazardous goods in ports have always been one of the human and environmental threats. The purpose of this research is to study the consequences of incidents involving dangerous goods by modeling and prediction of catastrophic consequences of these goods using the Software valid of management, so in addition to the affected area of the various outcomes of these goods, To provide the necessary management measures to reduce human and environmental toll on keeping dangerous goods in ports and warehouses to be paid.
Material and Methods: The study performed from PHAST and ALOHA software in the container terminal in the region of Bandar Imam Khomeini and, to verify the consequences of styrene of toxicity of dangerous goods, was used.
Results: According to the results of this study, the extent of pollution coverage (the forbidden region) at least a radius of 79 meters and the best place for placement the Support groups are a radius of 106 meters, around the area dangerous goods. Finally, to offer management practices to avoid or reduce the consequences of possible sites and warehouses storing goods in the study area was dangerous.
Conclusion: In this study, methanol reservoir was introduced as the main focus of risk; therefore, the implementation of safety rules, eliminating mechanical failures, personal protection and education, and effective measures to prevent and fight fire are proposed for decreasing the probable losses and fatalities are necessary. As well as measures such as drainage design and appropriate land cover of hazardous goods and predictions for emergency evacuation with regard to atmospheric conditions (speed and wind direction) were recommended.
Ali Fardi, Mohammad Karkhaneh, Hamidreza Heidari, Abolfazl Mohammadbeigi, Ahmad Soltanzadeh,
Volume 12, Issue 2 (6-2022)
Abstract
Introduction: Methane is one of the most widely used gases in industries with a high flammability potential. This study aimed to evaluate the efficiency of ventilation systems installed on methane valve pits based on hazardous areas classification.
Material and Methods: This study was implemented in a steel industry in Qom Province in 2019. The tools used in this study were a DELTA OHM pitot tube (DO-2003) to measure wind speed, EPA Protocol for equipment leak emission estimates (U.S. Environmental Protection Agency) and IEC-60079-10 for evaluating the safety of ventilation of methane valve pits.
Results: The methane LELm was about 0.0334 kg/m3, and the volume of the release area was approximately VZ = 0.053 m3. The expected leak emissions were within the Vz < 0.1 m3 range. The ventilation system embedded on methane distribution pipelines was not effective for openings with diameters of more than 0.3 mm and the volume of gas inside the valve pits would quickly exceed high ventilation border which might lead to a dangerous accumulation of gas in the valve pits.
Conclusion: Given that a very small opening or leak in gas transmission valves may lead to the formation of an explosive atmosphere, it is essential to monitor methane before entering the valve pit area and performing any operations on valve pits.
Mojtaba Zokaei, Milad Abbasi, Mohsen Vahidnia, Mohamad Zarie, Fardin Zndsalimi, Mohsen Falahati,
Volume 14, Issue 3 (10-2024)
Abstract
Introduction: Nowadays, the statistics prove that the underground construction projects in the country are increasing, as well as the number of accidents arising from the unsafe condition of these projects. The purpose of this study was to create a framework of safety and health risk management in the construction phase of the Tehran Metro Line 7 tunnel, using IoT technology.
Material and Methods: In the first stage, the national safety and health standards, laws and requirements related to the mentioned hazards were collected. In the second stage, the criteria and permissible limits of exposure to occupational hazards were determined. Next, sensors with optical, auditory, gas detection, and visual capabilities connected to the network were examined, and computer programming and comparing sensor information with the specified standards were carried out. Finally, intelligent warning and control systems related to the determined hazards were proposed.
Results: In this study, a combined model of risk management utilizing IoT for controlling and monitoring safety and health hazards such as sound, light, explosive and toxic gases was proposed. According to the model, sensors for detecting the mentioned hazards were determined and coded based on the permissible limit of each of the harmful factors.
Conclusion: This study has shown that by employing specialized IT and safety knowledge and utilizing relevant software and hardware, the concept of the Internet of Things can be utilized in precise monitoring of the concentration levels of flammable and toxic gases, as well as monitoring of physical agents such as noise and light in various workplace, such as metro tunnel construction sites.
