---

Background and aim: Asymmetric motions of trunk, external forces and other occupational factors such as frequent bending and twisting, lifting and forceful movement contribute to low back disorders. However, the dynamic and three-Dimensional motions of trunk at varying exertion levels were not addressed in literature. Hence, the aim of this study was to investigate the movement pattern and motor output during resisted trunk three-dimensional motion. 

Materials and Methods: Thirty healthy male subjects randomly performed dynamic asymmetric trunk motion at four resistance levels (nominal resistance, 25%, 50%, and 75% maximal voluntary contraction (MVC) torque) while positioned in standing with the L5-S1 interspinous space aligned with the flexion / extension axis of isostation B200. Under each resistance condition, movement patterns (range of motion), motor output (maximum torque) of the trunk were measured.

Results: In general, with increasing resistance from nominal to 75% MVC torque, the maximum torque of trunk in different directions of motion (flexion, extension, right & left lateral flexion, right & left rotation) increased significantly (p= 0.000). With increasing resistance from nominal to 50%  MVC torque, the range of motion of the trunk decreased significant (p<0.0083), but no significant change was found in this variable between resistance conditions of 50% and 75% MVC torque (p>0.0083).

Conclusion: When the resistance level is increased , the created external forces  must be balanced by internal forces generated by trunk muscles. Because the muscles have short lever arms compared with the external forces, they must generate large amounts of forces, placing compressive and shear loads on the structures of the spine. Under these conditions, spine injuries may be enhanced.

---

Background and aim: Muscles are involved in complex and three dimensional activities. Timing and response to onset of external trigger need to perception and processing of data in central nervous system. The propose of this study is to determine reaction time, pre motor time and motor time with and without external load in healthy subjects. 

Material and methods: Twenty healthy subjects contributed in this study. Isoinertial dynamometer was used to assess complicated motions in sagital, frontal and transverse planes from full flexion, rotation and lateral flexion to right side to opposite direction inclusive full extension, rotation and lateral flexion to left side without and with 25 and 50% MVE. Reaction time, pre motor time, motor time, and maximum torque were also measured.

Results: Following combined motions,  reaction time and pre motor time were increased by external load (25 and 50% MVE). Lateral flexion showed more changes than extension (P<0.001). By increasing load, particularly in extension time and maximum torque were changed (P<0.001).

 Conclusion: Reaction time and pre motor time in combined motions are affected under extension and lateral flexion motions. Rotation has less effect on combined motions. Motions occur in sagital and frontal plane more than transverse plane.